Symptoms
• Dishwasher stops mid-cycle and displays error code 10
• Water does not fill into the wash chamber
• Reduced water pressure or slow water flow during fill phase
• Cycle halts before washing or rinsing stages complete
• Door may lock and require manual reset
• Error code clears but returns on subsequent cycles
• Audible clicking from water inlet valve area during fill attempt
Possible Causes
• Clogged or kinked water inlet hose (cold water line connection)
• Failed water inlet valve (solenoid malfunction)
• Water supply line shut-off valve partially or fully closed
• Home water pressure below 20 psi (insufficient for USA standard plumbing)
• Debris blocking water inlet screens or filters
• Faulty water level sensor or pressure switch
• Frozen water supply line (in cold climates)
• Float switch stuck in closed position
• Control board communication error with inlet valve
Safety Checks You Can Do
• Verify the water shut-off valve under your sink or at the main water supply is fully open (turn counterclockwise)
• Check your home's circuit breaker box to ensure the dishwasher circuit breaker is in the ON position
• Inspect the inlet hose connection at the back of the dishwasher to confirm it is hand-tight and not kinked or pinched
• Look for visible cracks, splits, or damage to the water inlet hose along its entire length
• Disconnect the inlet hose from the dishwasher and allow water to run into a bucket to test home water pressure (should be 20-116 psi)
• Close the water shut-off valve, disconnect the inlet hose, and inspect the connection point for mineral deposits or debris
• Open the dishwasher door and visually inspect the water inlet opening at the bottom front interior for visible blockages
• Wipe the inlet area with a damp cloth to remove any debris or detergent buildup
• Run the dishwasher through a short cycle after reconnecting all connections to see if error clears
• Reset the dishwasher by turning off power at the circuit breaker for 30 seconds, then restore power
• Check that the door latch closes completely and engages fully (error 10 sometimes triggers on incomplete door seal)
• Ensure detergent dispenser door opens freely and is not blocked by loading items
Safety First
Always disconnect the appliance from power before performing any checks. If you are unsure about any step, please contact a qualified technician.