Symptoms
• Dishwasher stops mid-cycle and displays E11 on the control panel
• No water enters the wash chamber during the fill phase
• Water fills very slowly or not at all
• Dishes remain unwashed after a cycle completes
• Control panel beeps and the cycle halts prematurely
• Error code appears when starting a new wash cycle
• Water may drip weakly from spray arms instead of normal spray pressure
Possible Causes
• Kinked or pinched inlet hose between wall connection and dishwasher
• Clogged inlet filter screen at the water supply connection point
• Main water supply shut-off valve not fully opened
• Low water pressure in home plumbing system (below 20 psi)
• Frozen or blocked water line in cold climates
• Faulty water inlet valve solenoid preventing water flow
• Check valve in inlet line stuck or malfunctioning
• Municipal water pressure drops during peak usage hours
• Debris in water supply lines from recent plumbing work
• Defective water level sensor misreporting water presence
Safety Checks You Can Do
• Verify the main home water shut-off valve is completely open and not partially closed
• Check that the dishwasher's inlet hose is not kinked, crushed, or bent behind the unit
• Inspect the visible inlet hose connection at the wall for kinks or damage
• Turn off the dishwasher and pull out the inlet hose connection under the sink to check for debris in the filter screen
• Ensure water supply to other fixtures in your home is functioning normally to rule out a whole-house water pressure issue
• Confirm your home's water pressure is adequate by checking if water flows normally from kitchen faucets at normal volume
• Check your home's electrical panel to ensure the circuit breaker for the dishwasher has not tripped
• Run the dishwasher's rinse cycle alone to determine if the issue occurs on all cycles or specific programs
• Disconnect and reconnect the inlet hose connection to ensure it is seated fully and tightened properly
• Allow 30 minutes for the water inlet valve to reset, then attempt to run a new cycle
• Verify the door latch is fully engaging and the control panel responds normally to button inputs
Safety First
Always disconnect the appliance from power before performing any checks. If you are unsure about any step, please contact a qualified technician.